Volume 12, Number 3 and A (Transaction A: Civil Engineering September 2014) | IJCE 2014, 12(3 and A): 326-332 | Back to browse issues page

XML Print

Download citation:
BibTeX | RIS | EndNote | Medlars | ProCite | Reference Manager | RefWorks
Send citation to:

Eftekharzadeh S F, Khodabakhshi A. Safety evaluation of highway geometric design criteria in horizontal curves at downgrades. IJCE. 2014; 12 (3) :326-332
URL: http://ijce.iust.ac.ir/article-1-833-en.html

Abstract:   (1594 Views)
The previous studies show that a high percentage of traffic accidents take place in two-lane rural highways and most of which happen at horizontal curves. Meanwhile the horizontal alignment is often subject to hard topographic conditions where because of economic aspects designers are forced to design horizontal curves at grades. Vertical angle of longitudinal slope reduces the normal force of vehicle on road and friction force in tire-pavement surface will decrease. This leads to a lack of sufficient driver control over the vehicle especially if the curve with small radius is located at downgrade. In this paper, the suitability of operating speed and lateral friction coefficient as geometric design criteria for horizontal curves in downgrades are studied with regard to traffic safety and vehicle stability. The investigation of speed reduction of the vehicles running on a horizontal curve at downgrade as a response of driver behavior and the use of friction ellipse theory give the available friction coefficient. Whereas the dynamic analysis of forces applied on the vehicle in curve which is located at downgrade if combined with operating speed results in the required coefficient of lateral friction. Finally, a comparison of these two parameters based on safety evaluation criteria gives an estimation of actual safety level in designing horizontal curve at downgrades with regard to AASHTO’s data in horizontal curve design.
Full-Text [PDF 324 kb]   (771 Downloads)    
Type of Study: Research Paper | Subject: Transportation

Add your comments about this article : Your username or email:
Write the security code in the box

© 2015 All Rights Reserved | International Journal of Civil Engineering

Designed & Developed by : Yektaweb