The current building codes provide limited prescriptive guidance on design for protection of buildings due to progressive collapse. Progressive collapse is a situation in which a localized failure in a structure, caused by an abnormal load, such as explosions or other happenings. Three procedures, often employed for determination of the structural response during progressive collapse i.e. linear static procedure (LSP), nonlinear static (NSP) and nonlinear dynamic (NDP) analyses. In nonlinear static analysis, a force-based method is applied and the structure is pushed down to the target force. In this research, a new displacement-based method will be proposed for nonlinear static analysis. In displacement-based method, the structure is pushed down to target displacement instead of target force (similar to the one in seismic pushover analysis). To make a nonlinear static analysis, instead of increasing the load around the area of the removed column, a maximum displacement is calculated and the upper node of the removed column is pushed up to target displacement. Here, to determine the target displacement, results from nonlinear dynamic and linear static analyses are compared. This paper tries to present a formula to calculate the target displacement using the linear static rather than the nonlinear dynamic analysis. For this reason, 3 buildings with 3, 5 and 10 stories have been seismically designed and studied. The results show that, this method is much more accurate in comparison to the recommended approach in current codes. Also, this method does not have the limitations of force-based nonlinear static analysis.